Meyra 2.432 Especificações descarregar pdf (Página 14)

14

PUSH MODE

The POWER PRIMUS II can also be swit-

ched to push mode.

The electronic wheelchair has a consi-

derably higher weight than conventional

wheelchairs (motor, batteries). This me-

ans that higher pushing and steering for-

ce are necessary.

Note!

the wheelchair on level

surfaces.

The electromagnetic brake is switched

from drive to push mode by way of the

brake release lever on the side of the

wheelchair!

The brake release lever on the side of

the wheelchair is used to switch the elec-

tromagnetic brake from drive mode to

push mode!

– Controlled braking is

not possible!

Handling:

1. Switch off the wheelchair.

Press the I/O button (17) on the control

box.

2. Push mode

First pull the knob on the brake release

lever, then push the brake release lever

backwards. (Fig. 35).

Drive mode

Push the brake release lever forward,

(Fig. 36).

FOLDING/UNFOLDING

POWER PRIMUS II is also collapsible for

car transportation (Fig. 37).

FOLDING THE WHEELCHAIR

1. Switch off the wheelchair. – Switch

off the wheelchair with the I/O but-

ton (17) on the control box, (Fig.

38). The battery control display goes

off.

Note:

If the wheelchair has a seat width of

43 cm or less, remove the side parts

before folding and replace them after

unfolding.

Folding up the seat

2) Fold up the seat to the right (Fig. 39).

– To carry this out, lift the seat up out

of the seat tube (Fig. 40).

Removing the batteries:

3 Disconnect the battery plug (A) (Fig.

41).

4) Open the lock on the elasticated belt

(Fig. 42) – by pressing down the

spring release mechanism.

5) Lift out the front battery box (Fig. 43).

6) Lift out the back battery box (Fig.

44).

SEAT BELT

The seat (4) can be folded up to enable

better access to the battery holder (fol-

ding/unfolding the wheelchair) (Fig.

31).

Folding up the seat

Lift up the left seat mounting strip out of

the seat tube.

Inserting the seat

Press the fixing pins on the seat down

into the appropriate holes on the moun-

ting strip, which is located on the seat

frame, as far as they will go (Fig. 32).

Note:

To simplify the process of inserting the

stabiliser rod, lift it up or press it down

at the centre (Fig. 33).

The seat should fit flush to the tube

after mounting

(Fig.34).

– Press down the stabiliser bar at the

centre as far as it will go

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 37 38

Comentários a estes Manuais

Sem comentários